Welcome to the Veson Nautical Knowledge Base. In the Help Center, you can view the same articles and contact support as needed.
IMOS - Consumption Tab - Vessel
Home > Data Center > Consumption Tab - Vessel
The Vessel Consumption tab includes the following sections:
In Port Consumption Table
When adding a new Low-Sulfur fuel type to a Vessel that has an existing High-Sulfur type defined, Port/Sea Consumption rates default to being the same as the High Sulfur consumption rates if the new Low Sulfur fuel type is in the same Group as the High-Sulfur fuel type on the Fuel/Lube Types form.
When a Vessel Type is selected, and no fuel types are defined yet, the system defaults the Fuel Types, Units, and Grade according to the Vessel Type. If the vessel has not yet been used, changing the Vessel Type gives you the option to replace the existing fuel types with the default fuel types defined for the Vessel Type.
When the fuel type is H and an L fuel type exists in the vessel and is in the same Group on the Fuel/Lube Types form, you can copy consumption figures from the HS/LS corresponding fuel type. Right-click the Fuel Type and then click Copy consumption.
For LNG Vessels
Reliq, GCU/Steam, and Meter Adj consumption table columns replace Heat, Heat+, and Heat++.
You can include Bunker Curve Parameters in the calculation of fuel consumption.
Speed Consumption Table
Figures are separated into Ballast (B) and Laden (L).
When the Vessel Type has Restrict Speeds enabled, the speeds available are only those corresponding to the specific Ballast/Laden mode.
In an Estimate or a Voyage, if the designated speed does not exist in the vessel details, the Veson IMOS Platform will linearly interpolate between the available consumption data within the Ballast and Laden categories.
If conflicted, the fuel grade from Fuel Zones in the Data Center takes priority over consumption.
To set specific speeds for different fuel modes and consumption types, you can add new entries to the Speed Consumption Table for Secondary Fuel Cons Modes in the Vessel form. When a speed consumption line is added as a non-default mode, the speed reflects on Voyage or Estimate when the specific mode is assigned as a sea mode.
Variables and Safety Margins
Enter variables and safety margins for the vessel.
Beaufort, Sea State, and Sea Swell options are defined in the Data Center.
Still need help? Visit the Veson Nautical Help Center.
Copyright © 2017-2024 Veson Nautical LLC All Rights Reserved - Privacy Notice | End User Terms of Use